Installation Instructions
Table Of Contents
- Contents
- About This Document
- Key Concepts
- CLI Command Reference
- Overview
- Alarms Commands
- asc: Subcontroller Commands
- ats: Access Point Commands
- auth: RADIUS Authentication Commands
- Channel BSSID Commands
- connect or remote: Remote Connection Commands
- Console Commands
- db: Configuration Backup Commands
- Help Commands
- History Commands
- if...stats: Interface Statistics Commands
- if: Interface Commands
- qoS or codec: Quality of Service Commands
- qosrule or ruleQoS: Rule Commands
- Quit Commands
- Reboot (or restart) Commands
- security: RADIUS Security Commands
- SNMP Commands
- Station Commands
- topo: Network Topology Commands
- Watchdog Commands
- wirelessif or wif: Wireless Interface Commands
- wnc: Controller Commands
- Glossary
- Index
PRELIMINARY
CLI Command Reference 3
Revision 0.1, July 2003
Alarms Commands
Alarms Commands
These commands provide information about alarm or error status in the Meru wire-
less network.
alarms
Displays the controller’s alarm log.
Syntax alarms
Description Displays the controller’s alarm log file, showing the date and time of each event along
with the originating node and the severity of the alarm. The log lists all alarms for all
nodes in the Meru wireless network that have occurred since the controller’s most
recent reboot.
If there have been no alarms, the command displays
No entries.
Otherwise, the command lists the following information for each alarm:
Information Description
Time Date and time of the alarm in UTC (MM/DD hh:mm:ss), where:
MM = Month number (01 - 12).
DD = Day number.
hh = Hour (00 - 23).
mm = Minute.
ss = Second.
Node Consists of two parts:
Node Type, one of ATS (an access point), ASC (a subcontroller), or WNC
(a controller)
Node number within that type: An integer