Installation guide

46 Meru Access Point Installation Guide © 2009 Meru Networks, Inc.
Installing the Access Points
Figure 28: AP150 Antenna Connection
3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
connector, shown in Figure 30.
Figure 29: AP150 Connector Panel
Vertical Mounting the AP150
To perform a simple wall mount using the keyholes on the back of the AP150:
1. Remove the attached mounting bracket from the back of the AP150.
2. Mark the location on the wall for two mounting screws. They are placed 4.3"
apart, center-to-center, or one above the other. If you are not using plastic wall
anchors, you must either center the mounting screws on a wall stud or use plastic
wall anchors.
3. Drill holes at the locations you marked:
3/16-inch holes if you are using plastic anchors
1/8-inch holes if you are using only the screws
4. If you are using plastic anchors, install them in the holes.
00172
ANT 2
RELOAD
RESET
Turn clockwise
to tighten
A
ntenna
ANT1 ANT2
LAN
DC 5V
CONSOLE
RESET RELOAD
00173
Power Ethernet
connection
Console
port
Reset
button
Reload
Antenna 1 Antenna 2
(reserved)
(reserved)