Installation guide

36 Meru Access Point Installation Guide © 2009 Meru Networks, Inc.
Checking LED Activity
Checking LED Activity
Access point status LEDs are provided on the Ethernet connector and on the face of
the AP200.
Ethernet Connector LEDs
After the AP200 is connected, the LEDs near the RJ-45 connector should light, as
shown in Figure 26.
Figure 25: RJ-45 LEDs
The green LED on the left blinks if any Ethernet activity is taking place. If there is
no Ethernet activity, the LED is off. The LED on the right is solid green if an Ethernet
link is present. If no Ethernet link is present or connectivity is lost, the LED is off.
AP200 Status LEDs
Four status LEDs on the face of the AP200 also light, as shown in Figure 27.
Ethernet activity
Link present
00129