Installation guide

Installing the Access Points

Figure 16: AP200 Antenna Connection

3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet

connector, shown in Figure 18.

Figure 17: AP200 Connector Panel

Turn clockwise

to tighten

ntenna

ETHERNET

3.3 VDC

ANT 2

00110

Note:

For the AP201 and AP208 access points, a shielded Cat 5e (or greater)

Ethernet cable must be used in order to comply with international

electromagnetic emissions limits.

If it is not practical to use shielded cables, contact Support for a line filter,

available at no charge, that may also be used to ensure compliance.

Caution!

Be sure to connect the Ethernet cable to the Ethernet port; the cable can

mistakenly be plugged into the Console port (see Figure 18).

CONSOLE

ANT 1

ANT 2

3.3 VDC

ETHERNET

00108

100/1000

Ethernet

(Reserved)

Console

port

Antenna 1 Antenna 2

Power

inlet

Reset

(Push to restore

default settings)

(Currently

unsupported)