Installation guide

Install the AP300

Mount AP300 in a Hoffman Enclosure

Meru has designed a custom mounting bracket compatible with a Hoffman enclosure (www.hoffmanon-

line.com). This bracket is available exclusively through Meru and orderable as part number ACC-AP300-

BHE. To mount an AP300 in a Hoffman enclosure, follow these steps:

1. Place AP300 upside down on a soft flat surface.

2. Remove and discard the wall/ceiling mounting bracket if it is present.

3. Remove and discard the four rubber feet.

4. If the unit has white antennas, remove them and attach the black antennas provided.

5. Position the Hoffman bracket (ACC-AP300-BHE) onto the back of the AP300 with the four Hoffman

mounting screws facing downwards.

Figure 13: Hoffman Bracket ACC-AP300-BHE

6. Using a Phillips screw driver, attach the bracket using the two supplied 6-32 3/16 SEMS screws.

7. Flip the assembly over and mount into the Hoffman enclosure, attach the Ethernet cable to the

AP300 rotating the assembly to allow ease of dressing the Ethernet cable within the enclosure.

8. Using a Phillips screw driver, tighten the four bracket screws to the enclosure.

9. Adjust the antennas as needed.

00230