Installation guide

Install the AP300

Mount AP300 Below a Suspended Ceiling

z Mount AP300 Above a Suspended Ceiling (Plenum)

Mount AP300 Horizontally on a Shelf

When mounting an AP300 horizontally, remove the mounting bracket. Be sure to position the antennas

vertically when an AP300 sits on a surface.

Mount AP300 Vertically on a Wall

Note:

If you are replacing AP150s, you can use the existing brackets: the AP150 and AP300 use the

same bracket. If you are replacing AP300s, the AP300 bracket can be attached to the old bracket with

included shoulder screws; you don’t have to remove the old brackets. This bracket will also mount

seamlessly into the Proxim AP4000 bracket and standard Cisco brackets.

To mount an AP300 on a wall:

1. Using the bracket holes as a guide, mark the location on the wall for the two AP bracket mounting

screws. If possible, center the mounting screws on a wall stud. If you do not center the mounting

screws on a wall stud, use plastic wall anchors.

2. Drill holes at the locations you marked:

— 3/16-inch holes if you are using plastic anchors

— 1/8-inch holes if you are using only the screws

3. If you are using plastic anchors, install them in the holes.

4. Screw in the screws most of the way.

5. Mount the bracket on the screws, placing the circular portion of the keyhole mounts over the screw

heads and sliding the bracket down.

6. Connect one end of the Ethernet cable to the switch and the other end to the AP300 Ethernet port.

7. If you are not using a PoE device, connect an external power supply to the power connector and

plug it into the wall.

Mount AP300 Below a Suspended Ceiling

The optional suspended ceiling mounting kit (ACC-MNT-SCRMKIT) allows the AP300 mounting bracket

to attach to suspended ceiling T-rails (see Figure 10).

Note:

To comply with NEC code, attach a grounding wire to any of the screws used to attach the AP300

to the mounting bracket.