Installation guide

Install the AP300
© 2009 Meru Networks, Inc.Installing the AP300 13
Figure 7: AP310 Antennas 1-3
The following antenna connections are used during operation of the AP310.
The attached antennas must be the same model; if you replace one antenna, replace them all.
Attach the antennas to the connectors on the AP300 (see Figure 8). Rotate the knurled ring at the base
of the antenna clockwise to attach the antenna. The ring should be finger-tight.
Figure 8: AP300 Antenna Connection
Radio 1 Antenna Connectors for AP310 Radio2 Antenna Connectors for AP310
Ant1, Ant2, Ant3 NA
Note: Do not leave any antenna connectors unterminated. All antennas supplied
with the Access Point must be connected to the antenna connectors on the AP.
Caution! When changing the orientation of the antennas, be sure to slightly loosen the
knurled ring before moving the antenna. Retighten the ring afterward. Otherwise, you
might damage the internal cabling in the AP.
A
2
A
2
A
L
A
N
R
F
1
R
F
2
2
1
2
3
antenna
connector