User's Manual

17 / 84
© 2014 Mertik Maxitrol GmbH & Co. KG, All Rights Reserved.
ENGLISH
TO OPEN AND CLOSE SOLENOID VALVE/BURNER
NOTE: The latching solenoid valve cannot operate manu-
ally. If the battery runs down it will remain in the last
operating position. During normal operation the sole-
noid valve will be reset to the ON position when the
GV60 is switched OFF remotely.

Burner are ON.
  SET and
(small
      
Printed instructions are on the battery cover

  SET and
(large
      
AUX symbol on the display indicates the so-
lenoid valve is OPEN.)
NOTE: The operation of the AUX is blocked
in timer OFF mode, when the setting
of the
Nighttime Setback Tempera-
ture is “
”.
Figure 23: Instructions for Latching Solenoid Valve (on battery cover)
Burner OFF
Burner ON
LIGHT/DIMMER OPERATION
Light/Dimmer
 (light

  
   
turn ON the light or increase brightness.

-
crease brightness.

shuts OFF the light.

and hold the


NOTE: The light bulb icon is displayed during light/dim-
mer setting only. 8 seconds after the light/dimmer
has been set, the handset will automatically go into
temperature control mode (CSA version) or manual
mode (CE version).
OPERATING INSTRUCTIONS FOR OEM USE ONLY
CIRCULATING FAN OPERATION
Circulating Fan
The circulating fan has 4 speed levels from low (1 bar) to
high (4 bars).




and increase fan speed.

     
fan speed.

-
ton until all 4 speed level bars disappear.
NOTE: 8 seconds after the fan has been set, the handset
will automatically go into temperature control mode
(CSA version) or manual mode (CE version). The
fan starts 4 minutes after the gas opens (from OFF
or from pilot) at maximum speed and goes to the
displayed level after 10 seconds. The fan stops 10
minutes after the gas is OFF or at pilot.
MODES OF OPERATION

mode of operation in the following order:
MAN

TEMP
  
TEMP

TIMER

MAN
.
NOTE: Manual mode can also be reached by pressing either
the
 

MAN
Manual Mode
 

TEMP
Daytime Temperature Mode
(Appliance must be in standby mode; pilot
ignited)
The room temperature is measured and
compared to the set temperature. The

to achieve the Daytime Set Temperature.
 Light/Dimmer Setting Mode
Turns light/dimmer ON and OFF and ad-
justs brightness.