User's Manual
14 / 84
© 2014 Mertik Maxitrol GmbH & Co. KG, All Rights Reserved.
ENGLISH
FINAL CHECK
Observe several complete cycles to ensure proper opera-
tion. During these cycles the electronics will determine the
1. STOP! Read the safety information included before pro-
ceeding.
2. Turn main valve knob to the OFF, full clockwise
position.
O (OFF position).
gas is in the area around the appliance, including near the
If you detect gas STOP! Follow “WHAT TO DO IF
YOU SMELL GAS” in the safety information (page 3).
If no gas is present, proceed according to the Mertik Maxi-
trol Operating Instructions.
Minimum Gas Flow Adjustment
(Vented Units Only)
knob to OFF position and back until the valve opens.
2. The minimum rate can be set either by screwing in a cali-
minimum rate screw. Controls with adjustable screws
-
3. Turn the screw clockwise
to decrease the minimum
stops.
5. Close pressure tap(s) by turning the screw(s) full clockwise
. Check all connections/pressure tap(s) for leaks.
Changing the Fuel Type
(Vented Units Only)
GV60 is suitable for all gas types and can be converted to
Adjustments of pressure regulator, minimum rate and pilot
gas are according to above-mentioned instructions. To con-
vert for LPG CE it is necessary to block the pressure regulator
by turning the regulator adjustment screw fully to the bottom
limit (or the throttle adjustment screw fully to the upper limit).
INSTALLATION INSTRUCTIONS FOR OEM USE ONLY
FIRE OR EXPLOSION HAZARD. Attempted disassembly
or repair can cause property damage, severe injury or
death. Do NOT disassemble the gas valve; it contains no
serviceable components.
Figure 18: Conversion from one gas to another
Conversion Plug
NG position
LP position
180°
Conversion Plug
Reinstate the conversion plug by screwing it clockwise until
it bottoms out.
NOTE: Do NOT adjust and/or alter any components marked
with tamper indicating paint.