Users Manual Part 2

20 / 30
INSTALLATION AND OPERATING INSTRUCTIONS DRAFT FOR OEM USE ONLY
© 2019 Mertik Maxitrol GmbH & Co. KG, All Rights Reserved.
SELECTED
1 2
ON
AM
PM
OFF
ON TIME SETTING (PROGRAM 1):
7.
, , is displayed, is dis-
played shortly, and hour ashes.
8. To select hour press
or button.
9. To conrm press
button. , ,
is displayed,
displayed shortly,
and minutes ash.
10. To select minutes press
or but-
ton.
11. To conrm press
button.
OFF TIME SETTING (PROGRAM 1):
1 2
ON
AM
PM
OFF
12. , , is displayed, is dis-
played shortly, and hour ashes.
13. To select hour, press
or button.
14. To conrm press
button. , ,
is displayed, is displayed
shortly, and minutes ash.
15. To select minutes press
or but-
ton.
16. To conrm press
button.
NOTE: Either continue to PROGRAM 2 and set on and off times
or stop programming at this point, and PROGRAM 2 re-
mains deactivated.
NOTE: PROGRAM 1 and 2 use the same on (Thermostatic) and
off temperatures for
, and Daily Timer ( , , ,
, , , ). Once a new ON (Thermostatic) and / or OFF
temperature has been set, that temperature becomes the
new default setting.
NOTE: If
, or Daily Timer are programmed for PRO-
GRAM 1 and PROGRAM 2 ON and OFF times, these
become the new default times. The batteries must be re-
moved to clear the PROGRAM 1 and PROGRAM 2 ON
and OFF times and temperatures.
or Daily Timer ( , , , , , , ) selected
▪ Set ON time and OFF time using same procedure as “
se-
lected” (above).
▪
: Set ON time and OFF time for both Saturday and Sunday.
▪ Daily Timer: Unique ON and OFF times may be set for a single
day of the week, for multiple days of the week, or for every day
of the week.
▪ Wait to nish setting.
2ND BURNER FEATURE
The latching solenoid valve will open automatically after igni-
tion or after switching the system OFF, so that the maximum
ow of gas is supplied to both burners assisting with the ignition
process. After pressing the button for the 2nd Bruner the motor
will turn 7 seconds in the ON direction until the max. position is
reached.
1 2
ON
AM
PM
OFF
ON:
▪
To switch a burner ON, press the
button.
▪ displayed.
OFF:
▪ To switch the burner OFF, press the
button.
▪ disappears.
NOTE: The latching solenoid valve cannot operate manually. If
the receiver battery runs down it will remain in the last
operating position.
ECO MODE
AM
ON:
▪ Press
button to enter Eco Mode.
▪
is displayed.
OFF:
1. Press
button.
2. Press
or button to enter Manual
Mode.
3. Press button to enter Thermostatic
Mode.
4. Press button to enter Program
Mode.
CIRCULATING FAN OPERATION
AM
Circulating fan has 4 speed levels from
low (1 bar) to high (4 bars).
ON / SETTING:
1. Press
button and hold until
ashes.
2. Press
button to increase fan speed
and
button to decrease fan speed.
3. To conrm setting either press
but-
ton or wait (
displayed).
OFF:
Press
button until all 4 speed level
bars disappear.
NOTE: SETTING only. If the fan was not switched OFF after
last use, it starts automatically 4 minutes after ignition
at maximum speed and goes to the last set level after
10 seconds. The fan stops 10 minutes after the gas is
OFF or at pilot.