Users Manual Part 2
27 / 30
ENGLISH
INSTALLATION AND OPERATING INSTRUCTIONS DR AFT FOR OEM USE ONLY
© 2019 Mertik Maxitrol GmbH & Co. KG, All Rights Reserved.
1 2 1 2
1 2
1 2 1 2
1 2
Hand tighten M4 screws (not provided) to secure the module via the two pre-drilled screw holes.
Use only M4 screws to secure the module.
Figure 29
Max. AWG 12 / 2.5 mm
2
Receiver
B6R-R8P,
B6R-RAP
FAN, LIGHT / DIMMER, 2ND BURNER FEATURE
V Module G6R-BEAV3
ELECTRIC SHOCK HAZARD
▪ Read these instructions carefully. Failure to follow them could result in property damage, personal
injury, or loss of life.
▪ This control must be electrically wired and operated in accordance with all codes and local regula-
tions. Service and installation must be performed by a trained, experienced service technician.
▪ Do not use the module if you suspect it may be damaged.
4 levels from
60 % to 100 %
14 to 100 Watt
The appliance
manufacturer must
test levels with fan.
Levels may vary
with fan
characteristics.
Innitely variable
20 % to 100 %
0 to 100 Watt
NOTE: To connect
LED lights or 12 V
lamps a driver/
transformator is
needed.
Latching Solenoid Valve
GV-S60…
(Latching solenoid as
shown shuts off burner 2,
leaving on the burner 1.
For more information see
instructions
GV-S60-II-EN.DE.FR.NL…
or consult Mertik Maxitrol.)
Cable V Module-Receiver
G6R-CBV…
V Module G6R-BUMV3
Molex 39-01-4031
Molex 39-01-4041
Combination Control
GV60…
Mains Power
(115 / 230 V; AC)
NOTICE