User Instructions Part 1

INSTALLATION INSTRUCTIONS FOR OEM USE ONLY
© 2013 Mertik Maxitrol GmbH & Co. KG, All Rights Reserved.
10 / 28
ON-OFF
UP
DOWN
Relay with Cable G6R-CD... (50 V/ 0.6 A) G6R-CDB (240 V/5 A)
START
IN
Pilot Burner
Solenoid Valve (Required for Power Flue Control)
Wall Switch (Optional)
Power Flue Control (Optional)
Receiver B6R-R9(8)K... with handset L6R-H8,9TV4
Thermocurrent Cable SW with ON/OFF Switch Thermocurrent Cable TC
8 Wire Cable
Interrupter Block
Ignition Cable
COMBINATION RECIVER FOR POWER FLUE CONTROL AND AUX
Relay with Cable G6R-CL... (50 V/ 0.6 A) G6R-CPB (240 V/5 A)
GV60 Valve
For cable G6R- CPB strain relief required, min. 30 N (to be mounted by installer)
Auxiliary contact to switch ON/OFF an electrical load
Main Burner
For cable G6R- CDB strain relief required, min. 30 N (to be moun- ted by installer)
Also for Latching Solenoid Valve (AUX), see fi gure 11, page 8
Power Flue Control The B6R activates and deactivates an external electronic control (not available from Mertik Maxitrol). The fl ue electronic control starts automatically with ignition. The fl ue electronic control is deactivated if the GV60 is shut off or if the motor turns to pilot end-stop. The control starts again when the motor leaves the pilot end-stop. The external power fl ue control operates a fan and a solenoid valve. A pressure switch checks the draft. If there is the required draft the solenoid valves opens. For safety, the solenoid valve must close in case of a power outage. The solenoid valve should be installed between the GV60 and the main burner. (A pilot gas position is not possible upstream of the valve.)
Solenoid Valve (Required for Power Flue Control)
Main Burner