User Manual

5. Battery

5.1 Replacement

Use Alkaline battery (AA) only.

Remove the bottom cover, remove the screw which

fixes the circuit board, then turn the device upside-

down, the board will fall out easily. Replace the

batteries. (cross-slot screwdriver required)

Cautions:

Operate with antistatic gloves is preferred.

Avoid touching the circuit board other than the

battery holder.

Do not remove the battery holder from the circuit

board.

1 2

5.2 Cautions

CAUTION:

Disposal of a battery (or battery pack) into a fire or a hot oven, or mechanically crushing or cutting of a battery

(or battery pack) can result in an EXPLOSION!

Leaving a battery (or battery pack) in an extremely high temperature surrounding environment can result in an

EXPLOSION or leakage of flammable liquid or gas.

A battery (or battery pack) subjected to extremely low air pressure may also result in an EXPLOSION or leakage of

flammable liquid or gas.

Discard used batteries according to the manufacturer's instructions.

CAUTION: The unit is provided with a battery-powered circuit.

There is a danger of explosion if the battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer.

Discard used batteries according to the manufacturer’s instructions.

Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries according to the Instructions.