User Manual

BROWAN COMMUNICATIONS All rights reserved. 3
3. Operation
3.1 Transport Mode
They are shipped with batteries inside the sensor. Default the sensor is in transport mode which means not to activate
operation.
3.2 Installation Mode
 Users need to press the button over 5 seconds to activate operation into installation mode. When the Sensor
tries to join the network, it will keep blinking for 3 seconds.
 Once the sensor joins the network, the LED will keep on for 3 seconds and send an uplink.
 Users can press the button for over 5 seconds to try to join the network again.
 The device will send uplink three times with FW version when the device joined successfully.
3.3 Default Operation
● During default operation the device will send a message to the network anytime there is a sufficient delta in the
environmental conditions
○ Water leakage status change dry/wet (dry to wet Buzzer alarm)
○ Tamper detected (Buzzer alarm)
○ Button pressed (No buzzer alarm)
○ Keepalive message (No buzzer alarm).
● Users can press the button to send a test message to the network.
● The device will send a message saying it has been inactive for 60 minutes.
● While in default mode the device will flash the LED 3 times within 100ms only when the user presses the test
button.