User Manual

BROWAN COMMUNICATIONS All rights reserved 3
3. Operation
3.1 Installation Mode
 Users need to press the button over 5 seconds to activate operation into installation mode. When the Sensor
tries to join the network, it will keep blinking for 3 seconds.
 Once the sensor joins the network, the LED will keep on for 3 seconds and send an uplink.
 Users can press the button for over 5 seconds to try to join the network again.
 The device will send uplink three times with fw version when the device joined successfully.
3.2 Default Operation
 While in default operation the device will immediately send a message any time a control signal is transmitted.
○ Free to Occupied
○ Tamper detected
○ Button pressed
○ Keepalive message
 Users can press the button to send a test message to the network.
 The device will send a status message every 10 minutes while in the occupied state and every 1 hour while in
the vacant state.
 While in default mode the device will flash the LED 3 times within 100ms only when the user presses the test
button.
4. Messages
LoRaWAN Packets for this device use port 122.
4.1 Status
4.1.1 Triggers
Motion Sensor Triggers:
(1) While in free mode, send a message every 60 minutes;
(2) When the status changes from the free mode to occupied mode, send a message immediately;
(3) While the occupied state continues, send a message every 10 minutes;
(4) When the device isn't triggered by the occupied state again within 5 minutes from the last message, the status
changes from occupied to free mode and sends a message.
Tamper Trigger:
Immediately send a message
Button Pressed Trigger:
Immediately send a message