Service manual

Page 7 Microcook Ovens 32Z3385 Issue 4
Display Fault (frequency) Recommended Action
1
2
Door not fully closed
(permanent)
Magnetron
overheating
(Intermittent)
Check the door is fully closed.
Check the door down LED is illuminated on
the control board.
Check ribbon connector condition and fit.
Ensure the oven has been
installed correctly.
Check the magnetron cooling fan is
operating and free from obstruction.
1
2
Membrane panel
failure
(permanent)
Membrane panel
failure
(Intermittent)
Incorrect time set.
( Intermittent )
Replace membrane panel.
Replace membrane panel
Check correct time is set
ie : 1.00 minute Not 60 seconds
(TA only)
1
2
Microcook TA
Convected hot air
failure (permanent)
Intermittent
Check full / half wave LED
on control board
Check heating element
Error codes and diagnostics
The Microcook will identify some of the most common problems by flashing an error message code
in the time display window.
These are the error messages, and suggestions for repairing them.