User's Manual

6
This appliance must be connected to a
grounded, metallic, permanent wiring system,
or an equipment grounding conductor should
be run with the circuit conductors and con-
nected to the equipment grounding terminal or
lead on the appliance.
2 inches
2 inches
2 inches
2 inches
32 1/2 inches
In order to maintain adequate ventilation for air
intake and exhaust, and to allow access for
cleaning filters, you must allow a minimum of 2
inches ( 50 mm ) clearance at the sides and
rear of the oven, and at least 2 inches ( 50 mm
) above (Figure 3-1).
Air intake temperature should not exceed 60°F
excessive temperature will lead to reduced
operating duty cycle or premature ageing of
internal components.
Failure to comply with these conditions will
invalidate the warranty.
NEVER Install an oven above fryers,
grills, griddles or any other major heat source.
ALWAYS Place containers in the cavity
carefully - impact damage may chip the vitre-
ous enamel coating on the runners and baffle
plate.
4.00"
Figure 3-1 - Manufactures Recommended
Clearances
Figure 3-2 -Center Clearance Between Ovens
Positioning the Oven
Grounding Requirement
INSTALLATION INSTRUCTIONS