User guide

15
Error code display
Theovenwillidentifysomeofthemostcommonproblemsbyashinganerrormessage
code in the time display window.
Error code display
Fault Recommended action
Please remember - No servicing or repairs should be carried out other than by an approved Service Engineer
Door not fully shut.
Possible electrical fault
Oven has overheated
No time has been set.
Invalid time has been set. e.g. 61secs
The required cooking time for multiple
items exceeds 30minutes
Close door fully.
Call Merrychef Service Dept.
Cleanairlterandvents
Leave oven switched on but not cooking
for 4-5 minutes.
PROBLEM SOLVING
TechnicalSpecications
Height
( mm )
Width
( mm )
Depth
( mm )
500489 425
Microwave
Power output
( watts )
1725
Wt.
( kgs)
42.5
Pt No. 32Z3046GB Issue 5
Manufacturers recommended
clearances
50*50 50
Power Supply: See rating plate at rear of oven
This equipment complies with the following EEC directives:
EMC 89/336 EEC
LVD 73/23 EEC
Merrychefreservestherighttoalterspecicationswithoutpriornotice.
Display shows 0:00 but the cavity light
and cooling fans do not operate
Control panel lights do not operate with
oven connected to electrical supply.
Oven has gone into ‘stand-by’ mode, press
any pad to restart.
1. Check oven is connected to electrical
supply
2. Check fuse is correct value and in good
order.
3. Call Merrychef Service Dept.
Microcook HD1025 & HDV1025
1425
1025
42.5
40
*For 2 ovens side by side clearance is 100mm
each side
Remove one item and try again
Set a time
Set time in correct format 1:01
Microcook HD1425 & HDV1425
Microcook HD1725 & HDV1725
Microcook HD2025
Microcook HD1925 & HD1925
500489 500
650489 500
42.5
1925
2025
42.5