Specifications
Service & Parts Manual original Instructions
Part Number 32Z3811GB
Issue 1
35
TESTING
COMPONENTS
A
A
Soak Test16.8
Checking the oven cavity integrity.
Procedure:
Place an oven/microwave safe container with 16.8.1
approx. 2 litres of water into the oven.
Close the oven door and select ‘Soak Test’ (A) 16.8.2
from the Service mode oven tests (maximum oven
temperature, 50% microwave power, maximum fan
speed).
Run the test (30 minutes), carefully checking the 16.8.3
oven casing, joints and door seal for signs of steam or
water escaping from the oven cavity.
If necessary, rectify any leaks and repeat the test.16.8.4
Safely remove the container from the oven.16.8.5
Recommission Test16.9
The Recommission tests are performed following
the completion of a service or repair to ensure
the oven is operational before handing back to
the customer.
Some of the tests have a countdown timer where
failing to carry out a test within the time limit will
cause a test failure and the Recommission test will
have to be restarted.
Procedure:
Select ‘Recommission Test’ (A) from the service 16.9.1
mode oven tests and follow the on screen instructions
to perform the tests. Do not select the red ‘X’unless
you want to stop the test.
After a test has successfully passed, select OK to 16.9.2
continue.
When all the tests have been successfully 16.9.3
performed the display shows the Recommission test
has passed, select OK to conrm.
In the event of a Recommission test failure, 16.9.4
the detail will be recorded in the Error log. Any error
should be rectied and the Recommission test run
again.