User guide

Service & Parts Manual original Instructions

Part Number 32Z3813 US

Issue 1

SERVICING

VISUAL VIEW13.5

Select VISUAL VIEW (E) to check the main oven 13.5.1

components. Select a component symbol to switch

on (red), select again to increase the level or turn o

(green).

Remove the front air intake lter, the colour 13.5.2

should change from green to red on the display

indicating that the magnetic reed switch circuit for the

air intake lter is operating. Replace the lter and the

colour should change back to green.

Open the oven door and check the colour 13.5.3

changes from green to red on the display to check

the door microswitch/interlock circuit is operating.

Place door spacers onto the oven door (refer to Door

Interlock Adjustment (Testing Components section)

for details), close the door and check the colour on

the display. Green indicates the door adjustment is

ok, red indicates that the Door Interlock Adjustment

procedure must be completed.

Select the cooling fan and check it’s operating 13.5.4

correctly.

Place a microwave safe container of water into 13.5.5

the oven, close the oven door and select a magnetron

to test the current draw at maximum output, this

will time-out after 30 seconds. For dual magnetron

models, test the magnetrons individually and together.

Using heat proof gloves, remove the container and

close the oven door.

Select the Convection Fan and check it is 13.5.6

operating correctly.

Select the Heating Element, it increases to 13.5.7

maximum temperature then cycles (the Convection

Fan is on by default). Check the cavity temperature

and heater element current draw at maximum are

correct.