Operating instructions

12
Quick Start Guide original instructions.
Part Number 32Z3829 GB Issue 3
PRODUCT DETAILS
INSTALLATION
OVEN LOCATION AND POSITIONING
Choose a site away from major heat sources.
DO NOT position so that hot air is drawn in from fryers, grills, griddles,
etc.
A heat barrier to the height of the oven must be installed if sited next
to a burner, stove or range.
Place the oven on a permanent nonslip/nonammable at surface
that is LEVEL, STABLE and STRONG enough for the oven and contents.
Allow per oven, a minimum clearance (A) of 2 inches (50mm) around
the oven for hot air to escape.
Allow sucient clearance (B), in front of the oven for the door to open
fully.
The air intake is located at the rear top of the oven (1) and it is
important that the airow is as cool as possible and not preheated
by other appliances such as burners, stoves, ranges, fryers, grills
and griddles as this will deteriorate the life and performance of
the oven.
Do not ax labels/stickers to oven other than those applied or
approved by the manufacturer.
The appliance is to be supplied through a residual current device
(RCD) having a rated residual operating current of 30mA.
This appliance is intended for counter top applications, it is not
recommended to be placed on counter tops greater than 1100mm
from the ground or below a height likely to cause repetitive injury
or strain due to the ergonomics of its installation.
When installing ensure that it is safe to both remove and place
products into the oven without causing injury.
DANGER!
THIS APPLIANCE MUST BE EARTHED. FAILURE
TO DO SO MAY RESULT IN ELECTRIC SHOCK AND
DEATH.
The oven must be connected to a separate electrical supply
installed by a qualied and approved electrician.
A suitably rated isolating switch with a 3mm contact gap on all
poles should be tted for each oven installed.
If you are in any doubt about your electrical supply, seek the
advice of a qualied electrician.
HANDLING & STORAGE:
When moving an oven always observe and follow National and local
requirements for lifting and moving heavy objects. Do not use the
oven door handle to lift oven.
When not in use, electrically disconnect the oven and store safely in a
dry cool place, do not stack ovens.
Twin oven congurations
Position adjacent ovens allowing the minimum clearances shown. Note
that if a Parent oven is used, this is connected to the mains supply and
on the rear panel a mains socket for the Dependant oven is provided.
Do not plug any other appliance than
the Dependant oven into this socket.