User's Manual

16
Error code display
The Mealstream will identify some of the most common problems by flashing an error
message code in the time display window.
Error code display Fault Recommended action
Please remember - No servicing or repairs should be carried out other than by an
approved Servicer
Oven not heating up to
temperature
Possible component
Failure
Door not fully shut.
Possible electrical fault
Oven has overheated
No time has been set.
Invalid time has been set.
e.g. 61secs
Close door fully.
Call Service Agency
Clean air filter and vents
Leave oven switched on but not
cooking for 4-5 minutes.
Switch off and do not use
ISOLATE FROM
ELECTRICAL-SUPPLY
Call for Service
Remove food.
Wait until correct
temperature light is steady
Check the fuse/circuit breakers
and electrical supply (this should
be carried out by a qualified
electrician)
8. PROBLEM SOLVING
Set a time
Set time in correct format
1:01
Oven cavity is overheating
Possible component
Failure
Oven is not at correct
temperaturre
The oven is switched on
but the control panel does
not illuminate and fans do
not operate
Technical Specifications
Mealstream Series 5
Height
( inches )
Width
( inches )
Depth
( inches )
30.527.2 26.0
Microwave
Power output
( watts )
Convection
Power output
( kw )
1425 3.0
Wt.
( lb.s)
198
Power supply ( See Rating Label )
2P & G
3P & G
2P & G
3P & G
240V ac 30Amp 60Hz
240V ac 30Amp 60Hz
208V ac 30Amp 60Hz
208V ac 30Amp 60Hz
FCC ID PCV CTM3246015A
FCC ID PCV CTM3246035A
FCC ID PCV CTM3206035A
FCC ID PCV CTM3206015A