Service manual

Page 37
A) Fit motor assembly Pt. No. 11C0472 and secure finger tight with flange nuts &
washers.
B) Push the alignment tool (40C1211) onto the motor shaft and ensure initial step of the
tool locates into the wave trap. See figures 3a & 3b (see alignment tool figure 8)
C) Whilst supporting the weight of the motor assembly in one hand, tighten up the
securing nuts to 3.5Nm. This should align the shaft to the centre of the wave trap.
See figure 4
D) Remove the alignment tool and check shaft is centrally located. See figure 5
Note: Should the motor shaft not be central to the wave trap, follow the adjustment instructions
on the next page.
Note:
Ensure
motor shaft
is centrally
located
through the
wave trap
hole.
Figure 5
Figure 3a
Figure 3b
Figure 4
Earth point on
bottom left
mounting stud.
Step 10 Fit new hot air motor assembly Pt. No. 11C0472 (see diagrams below)
Make sure the motor shaft is centred in the hole
APPENDIX 5: Hot air motor replacement procedure 3