User's Manual

20
CLEANING: 2
Cleaning the oven cavity and door
2. Apply non-caustic oven cleaner to interior surfaces except door
seals. Leave for the recommended time. Wash off using a clean cloth
and plenty of clean, warm water. Dry using a fresh, clean cloth.
Wipe hinges with a clean, damp cloth.
DO NOT apply lubricating oil.
3. Wipe door seals carefully with a clean damp cloth.
Examine for signs of wear or damage.
If the door seals are
damaged, the oven must be
repaired by an approved
Servicer.
• ALWAYS switch off at the electrical supply and allow oven to cool for at least
20 minutes before cleaning
• CAUTION: Allow the oven and accessories to cool before commencing cleaning
• CAUTION: Wear protective rubber gloves when cleaning the oven
Hot surface
hazard
Merrychef recommends the
use of approved Merrychef
Oven Cleaner and Merrychef
Oven Protector.
Remove the rack and lift
out bottom impinger plate
rack
bottom
plate
fasteners
grease
filter
DO NOT SPRAY OVEN CLEANER INTO
THE BACK OF THE CAVITY
1. Remove the oven rack and lift out
the bottom impinger plate from
between the retaining pins on each
side. To remove the top impinger
plate undo the two thumb screws
and ease the plate forwards and
down.
To remove the grease filter at the
back of the cavity undo the six
thumb screws and lift out
Wash in warm soapy water. Wash
off using a clean cloth and plenty of
clean, warm water.
Dry using a fresh, clean cloth.
top
plate
bottom
impinger
plate
topimpinger plate
rack
Locating slot