User's Manual

14
Each program can comprise up to four stages, allowing at each, independent
control of Stage time, Microwave power level and Fan speed. However, programs
must be used with caution, since if the food to cook varies in weight or density,
adequately cooked food may not be achieved. Therefore, it is vital that all food
prepared for service should be checked to ensure that core temperatures have
been achieved.
Press the PROGRAM PAD
the display shows program mode.
Enter the cooking temperature by
pressing the NUMBER PADS.
1
2
3
Enter the cooking information for STAGE 1
of the program:
Some experimentation
will be required to
determine the correct
program for a particular
product.
Pre-programming allows repetitive cooking procedures to be stored for ease of
use.
PROGRAMMING NUMBER PADS 1
Enter a two digit number for the program from 00
to 99 using the NUMBER PADS.
e.g. 32
BACK
NEXT
ENTER PREHEAT TEMP
380°F
BACK
NEXT
e.g. 380°F
From a hot oven in standby
From a cold oven in standby
Press NEXT to move to the next stage.
Press next to move to the next stage
If a program is already in the memory the
temperature for this program will be displayed.
OVEN OFF
PRESS PREHEAT
READY
TO COOK AT 480°F
RUN PROG
MANUAL
PROGRAM NUMBER _ _
PROGRAM NUMBER 32
NO PROGRAM AVAILABLE
The display shows that no program is currently
stored
If a program is already in the memory the cook
data for this program will be displayed
Increase or decrease the fan speed
( in 5% steps) using the up/down arrows
e.g press down arrow 3 times, 35%
To change FAN SPEED
Enter a time using the number pads
e.g. 2 minutes 35 seconds
Increase or decrease Microwave power
(in 10% steps) using the up/down arrows
e.g. press up arrow twice, 70%
To change MICROWAVE POWER
To enter TIME
4
STAGE 1
TIME FAN POWER
BACK
NEXT
00.00 50% 50%
STAGE 1
TIME FAN POWER
BACK
NEXT
02.35 35% 70%