User guide

14
Each program can comprise up to eight stages, allowing at each, independent
control of Stage time, Microwave power level and Fan speed. However, programs
must be used with caution, since if the food to cook varies in weight or density,
adequately cooked food may not be achieved. Therefore, it is vital that all food
prepared for service should be checked to ensure that core temperatures have
been achieved.
Press the PROGRAM pad
the display shows program mode.
Enter the cooking temperature by
pressing the NUMBER PADS.
1
2
3
Enter the cooking information for STAGE 1
of the program:
Some experimentation
will be required to
determine the correct
program for a particular
product.
Pre-programming allows repetitive cooking procedures to be stored for ease of
use.
PROGRAMMING NUMBER PADS 1
Enter a two digit number for the program from 0
to 499 using the NUMBER PADS.
e.g. 32
ENTER PREHEAT TEMP
200°C
Back
Next
e.g. 200°C
From a hot oven in standby
From a cold oven in standby
Press Next to move to the next stage.
Press Next to move to the next stage
If a program is already in the memory the
temperature for this program will be displayed.
OVEN COLD
PRESS PREHEAT
READY
TO COOK AT 250°C
Run Prog
Manual
The display shows the name of the existing
program or that no program is currently stored
If a program is already in the memory the cook
data for this program will be displayed
Increase or decrease the fan speed
( in 5% steps) using the up/down arrows
e.g press down arrow 3 times, 35%
To change FAN SPEED
Enter a time using the number pads
e.g. 2 minutes 35 seconds
Increase or decrease Microwave power
(in 10% steps) using the up/down arrows
e.g. press up arrow twice, 70%
To change Microwave POWER
To enter a time
4
STAGE 1
TIME FAN POWER
Back
Next
00.00 50% 50%
STAGE 1
TIME FAN POWER
Back
Next
02.35 35% 70%
Note: This should match the Pre-Heat oven temperature.
This data is used to verify the oven is set correctly
READY AT 250°C
RUN PROGRAM _ _ _
Back
Next
PROGRAM NUMBER 32
NO PROGRAM AVAILABLE