Product Manual

Section 4: Maintaining the SHREDDER-CHIPPER
Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this manual and the
Engine Manufacturer's Owner's Manual for maintenance procedures. Service intervals listed in the checklist below supersede those
listed in the Engine Manufacturer's Owner's Manual.
Before performing any maintenance procedure or inspection, stop the Engine, wait five (5) minutes to allow all parts to cool.
Disconnect the Spark Plug Wire, keeping it away from the Spark Plug.
Regular Maintenance Checklist
PROCEDURE
BEFORE EACH USE
EVERY 8-10
HOURS
EVERY 40
HOURS
EVERY 100
HOURS
Check Engine Oil Level

Check General Equipment Condition

Check that the Shaft turns freely

Clean Engine Exterior & Cooling Fins

Inspect Knife for damage

Check Knife for Sharpness

Check Knife Attachment Screws

Check Rotor Hammers/Spacers for Wear

Check Side Bearing Collar Set Screws

Lubricate Side Bearings

Check Belt Tension and Condition
Break in period - once every
hour for first 5hrs

Clean Air Filter

Replace Air Filter

Change Engine Oil
1
st
time 5 hrs

Replace Drive Belt and Spark Plug

Reverse Rotor Hammers

15