Stability Chair User Manual

Stability Chair
™
Owner’s Manual
Replacement Parts
STABILITY CHAIR
SPRING PACKAGE
A complete spring replacement
package includes:
w
Light Chair Springs (2)
w
Heavy Chair Springs (2)
5-PRONG
STAR KNOB
Use to lock or unlock the pedals
3-PRONG KNOB
Use to lock or unlock the
chairhandles
POP-UP PIN
Use to adjust the height of the
chair handles
Optional Items
FOAM CUSHIONS
Available in three sizes. Used for
comfort and additional support
when performing a wide variety
ofexercises.
GRIPPER MATS
Non-slip rubber mats are
handy to increase traction and
preventslipping.
T.P.E. PILATES PADS
Non-slip, eco-friendly pads are
used to help establish correct
alignment and positioning or
provide cushioned support.
HANDLES
Updater kit for models without
handles. Includes hardware
andhandles
To order, visit merrithew.com/replacementparts or email [e-mail]
8
Assembly Instructions CONT’D
8 ALL MODELS Attach the springs to hooks on the pedal first,
then to the hooks on the vertical frame. The heavy chair (red) springs
[6] attach to the inner eyehooks and the light chair (blue) springs [7]
attach to the outer eyehooks.
NOTE: To change the spring tension, only unhook the springs
from the vertical frame. The springs should remain attached to the
pedals at all times.
9 SPLIT PEDALS
To split pedals: Loosen both 5-prong star knobs [9] and lift open
side of chair snap [8] from star knob and rotate so it is completely
under one pedal. Tighten both star knobs.
To join pedals: Loosen both 5-prong star knobs [9] and rotate
chair snap [8] to hook onto metal shaft of star knob. Tighten both
star knobs.