Cadillac Trapeze Table User Manual

7
13 REQUIRES TWO PEOPLE. Carefully place upholstered
bed [13] on top of bed frame [15] and ensure it
sits fully supported on all sides. This is easiest done
by tilting bed on a diagonal angle and sliding it
through the chrome uprights.
14 Slide washer onto eyehooks and insert eyehooks
[17] into holes near bottom of chrome uprights [26]
and below bed frame on black uprights [11].
Place second washer on other side of upright, thread
on bolt and tighten securely. Ensure eyehooks are
facing outward and positioned vertically.
TRAPEZE
Loosen star knobs and adjust the horizontally sliding
bar to desired position. Tighten star knobs securely and
attach trapeze springs to eyehooks on underside of
bar. Ensure spring clips are fully closed and the trapeze
strap is securely attached. Ensure the vinyl sleeves are
covering the lower part of the trapeze springs.
ROLL-DOWN BAR
Attach roll-down springs to roll-down bar, then
to the fixed eyehooks on the top frame assembly.
Both springs must be attached.
CAUTION: The roll-down bar can release at high
velocity due to spring tension. Ensure a secure grip
at ALL times. Gripper mats may be used.
LIGHT ARM SPRINGS
Attach light arm springs to eyehooks on vertically
sliding bar. Ensure spring clips are completely
closed and secure.
LEG SPRINGS
Attach leg springs to eyehooks on vertically sliding bar
or top frame assembly. Ensure spring clips are
completely closed and secure.
Safety & Usage
Full instructions on proper set-up and execution of each exercise is provided in the STOTT PILATES Cadillac training
manual. This safety manual includes general guidelines only.
6
7 Line up pre-drilled holes on chrome uprights [26]
with top frame assembly [2]. Insert hex bolts into
all four uprights and tighten securely.
8 Screw star knobs [1] into vertically sliding bar [21],
but do not tighten completely.
9 Move vertically sliding bar [21] to top of uprights.
Tighten star knobs [1] to hold bar in place.
11 Tighten one hex bolt [27] in place per upright
on short side of bed frame. Repeat at other end.
Subtle adjustments may be required.
12 Ensure vertically sliding bar [21] slides freely,
push-thru bar [12] rotates freely and bed frame [15]
is level. Tighten all remaining hex bolts [27]
securely. Insert hex bolts into base plates [19]
and tighten all securely.
10 REQUIRES TWO PEOPLE. Have one person lift bed
frame [15] while standing in the center. At one end,
have second person ensure height of frame is
22.75" (58cm) from top of frame to the floor.
Assembly Instructions CONT’D