Ladder Barrel User Manual

Ladder Barrel Owner’s Manual
4
IMPORTANT! PLEASE READ THESE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING ASSEMBLY.
Place all parts from the box in a cleared area and position them on
the floor in front of you. Remove all packing material from your area and
place them back into the box. Do not dispose of the packing materials until
assembly is completed. To prevent unsafe or improper use, please read each
step carefully before beginning.
For assistance or any missing parts:
Call: Toll-free in North America 1-800-910-0001
Toll-free in United Kingdom 0800-328-5676 or
Email [e-mail]
Please refer to the assembly instructions included in this Owner’s Manual for
initial Assembly Instructions and Part Identification.
Assembly
Center 32" maple dowel [1] on metal frame [4] as shown, so that 5" protrudes
on either side [fig. D]. Tighten
3
⁄8" x
3
⁄4" socket head cap screws securely, [8]
using
3
⁄16" hex key.
Adjustment
The Ladder Barrel can be easily adjusted to accommodate different body sizes.
To adjust barrel, loosen all four star knobs (located immediately above sliding
frame) [fig. E] and move sliding base along
metal frame.
Secure by tightening all four star knobs.
Figure D Figure E