User Manual

merrithew.com
5
PLEASE DO NOT ATTEMPT TO ASSEMBLE ON YOUR OWN.
Installation of this product requires a minimum of two people.
We highly recommend that you have this product installed by
a professional contractor. Read these instructions completely
beforebeginning assembly.
IMPROPER INSTALLATION VOIDS EQUIPMENT WARRANTY.
MERRITHEW will not be responsible for any injuryor damage
resulting from improper installation.
w
Place all parts from the box in a cleared area and
position them on the floor in front of you.
w
Remove all packing material from your area
and place them back into the box.
w
Do not dispose of the packing materials
until assembly is completed.
w
To prevent unsafe or improper use,
please read each step carefully before beginning.
For assistance or any missing parts:
Call: Toll-free in North America 1-800-910-0001
Toll-free in United Kingdom 0800-328-5676
Email customercare
@
merrithew.com
Please refer to the assembly instructions included in this Owner’s
Manual for initial assembly instructions and Part Identification.
Assembly Instructions
1 Remove the
3
⁄8"x
3
⁄4" hex bolts (plain) from the three-way joint
on the horizontal frame.
2 Place the open end of the 3-way joint onto the vertical frame.
Tighten both
3
⁄8"x
3
⁄4" hex bolts fully to complete the frame.
3 Find support studs in wall (typically 16"/ 40.64
cm apart)
NOTE: On a standard drywall surface, when only one support stud
can be found, affix the remaining hole of the wall plate to the
wall using butterfly toggle anchors, slotted hex head wall anchors
or other appropriate heavy-duty drywall anchor fasteners.
4 Place frame against wall, using a “square” or level to ensure
frame is at a 90° angle. To adjust, hold base plate of horizontal
frame against wall and move vertical frame.
5 Mark holes on wall and floor to mount plates. Select appropriate
hardware and attach the frame to wall and floor.
6 Attach all springs as pictured.
7 Test the stability and solidness of the Wall Unit before using.