Use and Care Manual

4
12. Press the start button again and press or hold ▲ or ▼ to increase or decrease the timer
setting.
13. Press the start button a third time. The platen will heat and transfer your design while the
timer counts down. When the timer sounds, raise the platen using the pressure lever and
slide out the base using its handle.
If heating needs to be IMMEDIATELY stopped for any reason, use the emergency
stop button on the side of the platen. Do not use the normal controls or attempt to
pull out the plug.
14. Carefully and evenly remove the transfer paper from your substrate, which should retain
your design. When you can safely handle it, move your substrate to another fl at location to
fully cool.
15. Make any necessary adjustments to the press’s pressure, temperature, and timer and then
complete any other work in the same fashion.
16. After your prints have fully dried, you can completely fl atten them by reheating the press,
spraying them lightly with clean water, and pressing them again.
17. When your current batch is done, remove the mats from the base and close the platen.
18. Turn off the press, flipping the power switch to O. Disconnect the device from its power
source.