Instructions / Assembly

V20200516
INSTRUCTIONS
ASSEMBLY
1. Prepare the wiring in your wall for the desired location of your new lamp. Prepare your junction box
(not included).
2. Install your bulbs (A) into their sockets. This fixture has been rated for up to two G9 4-watt maximum bulbs.
3. Screw the lamp shade (B) into the lamp holder (E).
4. Take the wall bracket (D) off the canopy (C). Connect your wall bracket to your junction box (not included)
using the mounting bolts (F).
5. Make electrical connections using the wire nuts (G).
6. Being careful that no wiring is left exposed, place the canopy against the mounting surface. Secure the
canopy to the wall bracket with the 2 previously removed canopy bolts (H).
CONTACT US
Thank you for your purchase! If you have any questions or concerns, contact us at [e-mail]
and we'll resolve your problem ASAP. Customers are always the best teachers to keep us growing!
Bulbs (A)
Lamp Shade (B)
Lamp Holder (E)
Canopy (C)
Wall Bracket (D)
Wire Nuts (G)
Canopy Bolts (H)
Mounting
Bolts (F)
Junction Box
Read these instructions carefully prior to installation.
● Check for electric, gas, and plumbing lines before drilling or consult a professional.
● ALWAYS cut ALL relevant power before installing a lighting fixture, and do not restore power to the line until
the lamp has been FULLY installed.
● DO NOT use with bulbs exceeding the recommended wattage.
WARNINGS