Use and Care Manual

3
ASSEMBLY
1
Loosen and pull the frame (5 & 7)
open as shown in Fig. A. Put the
two lifting columns (2 & 10) onto
the frame and tighten as shown in
Fig. B.
2
Install the bases (1) on the lifting columns
with the bolts M6×16 (19). Install the foot
pads (25) on the bases.
3
Connect the transmission tube (8) and
tighten as in Fig. C. Adjust the gear box to
align with the hexagonal bar (9) as in Fig. D.
Insert the hexagonal bar into the
transmission tube and gear box. Tighten as
in Fig. E.
E
C
D
A
B