Specifications

ManualsBrandsMerlin ManualsGarage Door OpenerMT5580P

PROGRAM YOUR OPENER & REMOTE –

Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while

door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door.

Your garage door opener receiver and remote control transmitter are set to a matching code. If you purchase additional remote controls, the garage

door opener must be programmed to accept the new remote code. Program the Receiver to Match Additional Remote Control Codes:

Using the “LEARN” Button

1. Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds (1).

2. Within 30 seconds, press and hold the button on the hand-held remote that you wish to operate your garage door (2).

3. Release the button when the motor unit light blinks. It has learned the code. If light bulb is not installed, two clicks will be heard (3).

Using the Motion Detecting Control Panel (optional accessory):

1. Press and hold the button on the hand-held remote that you wish to operate your garage door (4).

2. While holding the remote button, press and hold the LIGHT button on the Motion Detecting Control Panel (5).

3. Continue holding both buttons while you press the push bar on the Motion Detecting Control Panel (all three buttons are held) (6).

4. Release buttons when the opener light blinks. It has learned the code. If the light bulb is not installed, two clicks will be heard (7).

To Erase all Remote Control Codes

To deactivate any unwanted remote, first erase all codes:

Press and hold the “learn” button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased.

Reprogram each remote or keyless entry you wish to use.

1 32 74

LIGH

LIG

LOC

PROGRAM YOUR RADIO WALL CONTROL -

Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while

door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door. Locate mini-

mum 1.5m above the floor.

Remote control slide-on wall mount bracket:

-Attach to the wall with 2x ø 3.5 max.flat head screws

(not provided )

-Slide remote control onto wall mount bracket

NOTE: Tightening the wall mount screws will reduce clearance between bracket and wall.

Program the Receiver to Match Additional Remote Control Code

Using the orange “LEARN” Button:

1. Press and release the orange “learn” button on opener.

The learn indicator light will glow steadily for 30 seconds.

2. Within 30 seconds, press and hold the button on the radio

wall control that you wish to operate your garage door.

3. Release the button when the opener light blinks.

It has learned the code. If the light bulb is not installed, two clicks will be heard.