Instruction manual

1. Press and release the purple “learn”
button on motor unit. The learn
indicator LED will glow steadily for 30
seconds.
2. Within 30 seconds, enter a four digit
personal identification number (PIN)
of your choice on the keypad. Then
press and hold the ENTER button.
3. Release the button when the motor
unit LED truns off and two clicks are
heard.
To Add, Reprogram or Change a Keyless Entry PIN
(OPTIONAL)
USING THE “LEARN” BUTTON
c
l
i
c
k
c
l
i
c
k
To change an existing, known PIN
If the existing PIN is known, it may be changed by one
person without using a ladder.
1
. Press the four buttons for the present PIN, then press and
hold the # button.
The operator will click twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then
press Enter.
The motor unit will click once when the PIN has been
learned.
Test by pressing the new PIN, then press Enter. The door
should move.
To set a temporary PIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours
or number of accesses, this temporary PIN expires and will
no longer open the door. It can be used to
close the door
even after it has expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the
last temporary PIN), then press and hold the ] button.
The operator will click. Release the button.
2. Press the temporary 4-digit PIN you have chosen, then
press Enter.
The operator will click four times.
3. To set the number of
hours this temporary PIN will work,
press the number of hours (up to 255), then press ].
OR
3. To set the number of
times this temporary PIN will open
door, press the number of times (up to 255), then press #.
The operator will click once when the temporary PIN has
been learned.
Test by pressing the four buttons for the temporary PIN, then
press Enter. The door should move. If the temporary PIN was
set to a certain number of openings, remember that the test
has used up one opening.To clear the temporary password,
repeat steps 1-3, setting the number of hours or times to 0 in
step 3.
One Button Close: Opener can be closed by pressing only
the ENTER button if the one button close feature has been
activated. This feature has been activated at the factory. To
activate or deactivate this feature press and hold buttons 1
and 9 for 10 seconds. The keypad will blink twice when the
one button close is active. The keypad will blink four times
when one button close is deactivated.
21