Manual

from simultaneous discharge of both barrels. The front trigger also can
function as a set (hair) trigger and can be set by pushing the trigger for-
ward. NEVER fire the rear trigger with the front trigger in the set
(hair) position as both barrels could fire simultaneously. Note: The
front trigger can be operated in its set (hair) mode for either the rifle
barrel or the right shotgun barrel.
TOP LEVER
The top lever operates the locking bolt, which securely aligns and clasps
the barrel assembly shut to the receiver for firing. The locking bolt and
barrel lugs are designed for gradual wear of locking surfaces and may
therefore exhibit tight fitting characteristics during initial use. The close
tolerances of these locking surfaces ensure that the breech of the firearm
remains tight throughout use.
When closing the breech of the action let the top lever move freely to
its locked (in line with the safety) position (see figure 8). Do not restrain
its travel with your thumb.
It is recommended that the top lever be indexed to the left with slight
finger or thumb pressure to make sure that the bolt is fully closed. If the
bolt does not fully close it is possible that dirt or debris has accumulated
to a level preventing full closure of the breech. In this condition open
the action and unload the firearm. Carefully inspect the action and
remove any dirt or foreign matter. Keep the polished breech surface
clean and lightly lubricated.
EXTRACTORS
Merkel Drillings are equipped with extractors. When the action is
opened, the round casings are elevated above the chamber for removal
by hand.
LOADING AND FIRING
Before loading the firearm, visually inspect your safety and make sure it
is in the “Safe” position. Never load the firearm with the safety in the
firing positions. Avoid contact with the trigger mechanism while loading
ammunition and at all times prior to firing.
22