Manual

DRY FIRING

ATTENTION!!!!! Dry firing or pulling the triggers without live

ammunition is not recommended without the use of snap caps.

Snap caps absorb the inertia of the firing pins and protect inter-

nal parts from the full impact force of the hammers. Continuous

dry firing can potentially damage the internal parts and render

the gun inoperable.

DISASSEMBLY

Remove loaded ammunition from the chamber before disassembling the

shotgun. To disassemble the shotgun, grasp the shotgun barrel with the

non-firing hand and rest the buttstock against the upper leg. Pull the

forearm take down latch out and away from the forearm and pivot the

forearm away from the barrels.

Push the top lever to the right and carefully open the action to rotate

the barrel lug away from the receiver hinge pin and separate the barrels

from the receiver. The forearm can be reattached to the barrels for stor-

age.

Do not attempt further disassembly beyond barrel and forearm

removal!!! Further disassembly is not necessary for routine maintenance.

Any damage incurred due to further disassembly is not covered by your

service agreement.

FURTHER DISASSEMBLY BY UNQUALIFIED

PERSONS COULD CAUSE DAMAGE TO THE

SHOTGUN WHICH COULD RESULT IN

INJURY OR DEATH TO THE SHOOTER.