Owner`s manual

COPYRIGHT

1997 MERIT INDUSTRIES, INC.
PM0109-0D MEGATOUCH™ XL MANUAL 3
4. Exit Run 21 and enter the Hoop Jones game
screen. Make sure that the court surface is
greenish in color and look for a clean, white
border around the number on the player’s jersey.
5. Exit Hoop Jones and enter the Great Solitaire
game screen. Make sure that the game
background is a light, greenish-gray.
Maintenance
Cleaning the Cabinet
•
The cabinet should be cleaned with a damp cloth
and mild detergent.
Cleaning the Touchscreen Monitor
•
The touchscreen glass should be cleaned with a
damp cloth and isopropyl alcohol or a non-
ammonia cleanser. Do not use any abrasive or
vinegar-based cleansers, as they will damage
the touchscreen glass.
To gain access to the entire surface of the monitor
screen on the upright model, you will have to release
the monitor door latches. To do so, open the coin
mech door. Located inside, above and to the right
and left of the coin mech, are two monitor door
latches. Loosen the thumbscrews securing the
latches and rotate the latches to release the monitor
door. See Figure 5.
To gain access to the entire surface of the monitor
screen on the cabaret model, you will have to
release the monitor door latches. To do so, open the
coin mech door. Located inside, above and to the
right and left of the coin mech, are two monitor door
slide-latches. Loosen the thumb nuts securing the
latch and slide the latch open. Pull up on the bottom
of the bezel to remove it (NOTE: TO FULLY
REMOVE THE BEZEL, YOU MUST DISCONNECT
THE GROUND BRAID).
To gain access to the entire surface of the monitor
screen on the countertop model, you will have to
remove the top of the machine. To remove the top of
the machine, unlock and open the rear door.
Disconnect the fan power connector and disconnect
the plastic tubing and ground strap attached to the
lid. Press up on the spring-loaded levers located on
each side of the lid. Push the lid forward and pick it
up to remove. See the decal inside the lid for a
diagram of locations.
NOTE: DO NOT USE ANY ABRASIVE SOLVENTS, ACID OR
VINEGAR-BASED CLEANSERS ON THE MONITOR OR
SIDE DECALS. OVER TIME, SUCH CLEANSERS
COULD HARM THE TOUCHSCREEN AND ERASE THE
DECALS. BE CAREFUL NOT TO USE COMMERCIAL
CLEANERS CONTAINING ANY OF THESE
SUBSTANCES.
Cleaning the Compact Disc and CD Player
•
Clean the CD and CD player approximately
every 90 days, or if you experience any problems
with the CD player.
•
CD cleaning supplies can be purchased from
your local record store or audio supply house.
To activate the game for use with a CD-ROM lens
cleaner, turn off the game and set DIP Switch 2-1 to
“ON.” Turn on the game and follow the instructions
displayed on the screen.
Fan Operation
•
To ensure proper operation of the game, it is
important that all fans are operating correctly
and that the air flow is unobstructed. Make sure
nothing is placed inside the cabinet or next to the
fan vents that would inhibit the flow of air. Also, if
any fans are not operating, it is important that
they be replaced.
Troubleshooting
Coin Jam
The game also has coin jam and stringing detection
software. Should a coin become jammed in the
mech or someone tries to string the mech, a
continuous tone will be emitted by the game and the
words “COIN JAM” will be displayed on the screen.
If the game emits the coin jam indicator sound when
powered up, this may indicate that the NORMALLY
CLOSED contacts of the coin mechanism are being
used. The NORMALLY OPEN contacts must be
used.