Installation guide

Option Values Description
Enabled Yes, No Whether the source appears on the list of sources.
Audio input (G91A only) A1-A3, D1-D2, O1-O2, Disc, Tuner The audio input used for the source; analogue, digital, optical, and
internal.
Sensitivity (G91A only) 2.5V, 2.0V, 1.0V, 0.7V Allows you to set the sensitivity of the analogue inputs.
Video input V1-V2, S1-S3, Y1, Bypass, Disc Video input used for the source.
Video lock Normal, Poor Improves locking for poor video sources
Trigger High, Low Trigger output for the source.
HDMI switch 1 to 4 Available if HDMI switch is set to On in the HDMI setup menu.
Allows the G91A to control the input on the HDMAX 421.
Comms cat/add -C, 1C-9C, NC/1A-8A Allows you to set the Comms category and address.
Configuring
the DVD player
44
If you are using the DVD player as the controller or video switcher
in your Meridian system, you can use the Source setup option on
the Setup menu to configure each of the sources.
• Highlight Source setup… in the Setup menu, and press Enter.
The Source setup menu will be displayed:
To configure a source
• Press the source key on the remote corresponding to the source
you want to configure.
The Source configuration menu shows the values of each option
defined for that source.
To change an option
• Highlight the corresponding option in the Source
configuration menu and press Enter, select the value you want
to use, and press Enter to select it.
The following table explains the function of each of the options:
Configuring the sources