User guide

74
Troubleshooting
General operating problems
Standby light not lit
Check that the AC power supply is connected
correctly.
Check that the ON OFF switch on the back panel is
in the ON position.
If the light still does not illuminate, check any fuses in
your power supply and the fuse in the inlet of the G65.
If these are all intact, contact your dealer.
Erratic or unexpected system behaviour
Redo the Auto Configure process as follows:
Put the whole system into standby.
Make sure you are operating the MSR+ from a
position where all the units can receive the infra-red.
Press Clear on the MSR+.
Observe all units responding correctly.
In extreme cases, the memory of the G65 may have
been corrupted. If this is suspected perform a full reset;
see Resetting the product , page 45.
Remote not working
Check the following:
The battery in the MSR+.
Remove the Comms connections from the G65
and check whether it responds now. If so, replace
the connections and perform an Auto Configure
procedure; see To connect to other Meridian G
Series or 800 Series equipment , page 41.
See if the G65 has been set up as Not Controller
in the Configuration Menu; see Configuring other
settings , page 51.
Note: This may be deliberate by your dealer.
•
•
•
•
•
•
•
•
•
When playing a Dolby Digital DVD, the
G65 selects a two-channel preset
DVDs include a two-channel Dolby Digital soundtrack,
which will use the default two-channel preset.
Select a six-channel soundtrack, if it is available.
Unit is overheating
Check that there is adequate ventilation around the
unit.
•