User guide

63
Configuring the G65
Digital Surround
Controller
To adjust the source input sensitivity
This section explains how to use the Sine/Sub/
Sens controls to adjust the sensitivity of the analogue
sources.
To obtain the best signal-to-noise ratio for each
analogue source you can adjust its sensitivity to give
the highest level that does not produce clipping.
Select the source you want to adjust, with loud
source material playing.
Display the Sine/Sub/Sens controls as described
above.
Press Sens- or Sens+ to decrease or increase the
sensitivity.
The display shows the current sensitivity and the peak
level; for example:
Sine -Xover+ -Sens.+
T
V 1.4V Peak -3
You can adjust the sensitivity between 0.7, 1.0, 1.4,
2.0, and 2.8V (least sensitive).
If the sensitivity is set too high the input will clip the
loudest passages, and the peak will be 0dB.
The display shows, for example:
Sine -Xover+ -Sens.+
T
V 2.0V Clip -0
In this case reduce the sensitivity by selecting a higher
number.
If you have selected a digital source you cannot adjust
the sensitivity and the display shows, for example:
3INE 8OVER 3ENS
$6$.OTANALOGUE
•
•
•