User guide

56
Configuring the G65
Digital Surround
Controller
Introduction
We recommend that you perform the calibration
procedure using the MSR+ and from the listening
position.
As you run the calibration procedure the name of each
calibration test is shown on the front-panel display,
followed by the parameters adjusted in the test.
Each calibration test uses a test signal designed to give
the best results.
Using a Sound Pressure Level meter
Although you can perform the calibration procedure by
ear, it is recommended that you perform the tests using
a Sound Pressure Level meter.
Set the Sound Pressure Level meter to C weighted,
and Slow. Take readings with the meter at the listening
position, pointing vertically. You should hold the meter
with an outstretched arm to minimise reflections from
your body.
You can choose to display and enter distances in either
feet and inches or metres.