User guide

52
Configuring the G65
Digital Surround
Controller
Settings
The following table summarises the product settings:
Option Values Description
The fan is: used as necessary, never used Specifies how the optional temperature controlled fan
operates.
Distance measurement: feet/inches, metres Units for displaying and entering distances.
Do your subs play to 20Hz? No, THX Ultra2/yes Subwoofer frequency response.
Boundary Gain
Compensation:
off, on Reduces the bass to compensate for listening positions
close to a wall.
Rear speaker separation <12"/0.3m, 12-48"/0.3-1.2m,
>48"/1.2m
Separation between rear speakers; only available when
there are four surrounds.
Timeout to Home buttons: on, off Whether the soft keys revert to the home keys after a
delay.
Diagnostic displays: on, off Whether diagnostic displays are shown.
Is the G65 IR Controller? Auto, Controller, Not Controller Whether the product is the infra-red controller for the
system.
Main System Address 1-8 Advanced setting (normally 1).
Product Address 1-8 Advanced setting (normally 1).
EBA on SpeakerLink? off, on, Music streams only, all
audio streams
Whether to show the EBA menu or force the setting to
off or on.
Legends on SpeakerLink? no, yes Whether to show the custom source labels with a mix
of older DSP and newer SpeakerLink loudspeakers.
Centre speaker is
horizontal?
no, yes Whether to show the centre elevation menu.
To toggle the IR mode
If necessary press On/Off to put the surround
controller into standby.
Press More.
The display shows:
,OCK#ALIB6ERSION )2 7IZARD
•
•
Press IR to toggle between IR Auto (auto setup),
IR Con. (controller), and IR N.Con. (not controller).
After a short delay the surround controller will return to
standby.
•