User guide

47
Configuring the G65
Digital Surround
Controller
Stage 2: Configuring speakers
The Speakers configuration stage allows you to set
up the digital surround controller for the particular
arrangement of loudspeakers in your system.
To configure the speakers
Either:
Press Next after resetting the product; see page 45.
Or:
Press Wizard; see To run the Configuration Wizard ,
page 44.
Press Skip to skip past the Reset settings menu.
The display shows the title screen for stage 2:
3KIP"ACK %NTER
3ELECTSPEAKERS
0RESS-OREFORHELP
Press Enter to proceed or Skip to go to stage 3.
The display shows the first speaker configuration
option:
z{|wxy"ACK .EXT
.UMBEROF3UBWOOFERS
ONE
Press Next or Back to step between options.
A description of each option is shown on the top line of
the display, and its current value is shown below this to
the right.
The options are summarised in the table on the next
page.
To change an option
Press A or V to step between the alternative values
for the option.
•
•
•
•
•
•
•
•
When you have stepped through all the speaker options
the display shows:
"ACK .EXT
3PEAKERCHOICEFINISHED
Either:
Press Next on the last option of the last speaker to
proceed to configuring sources, as described in the
next section.
Or:
Press On/Off to return to standby.
If you press On/Off before completing the
configuration a warning is displayed, giving you the
option of continuing or abandoning the configuration.
•
•