User guide

40
Installing the G65
Digital Surround
Controller
R
On Off
Optical Input
O2 O1
Master
(One only, This Row)
L+R C+Sub
RightLeft Centre Sub
Rear
Right
Rear Left Side/Sub Left
Side/Sub Right
Side L+R Rear L+R
MD1
A8 A7 A6 A5 A4
Analogue Input
L
Multi Analogue Input
MA1
Surr L Centre Left
Surr R LFE
Right
Digital Input
MMHR
SpeakerLink Input
SpeakerLink Output
Meridian Comms
Maintenance
USB RS232
Analogue OutputAnalogue Output
D6
D5
D1
D3
SL1
SL2
D4 D2
Trigger 1
+12V 100mA
IR In
Mic
Voltage
Meridian DIN Comms
Power & fuse
USB connection
Infra-red repeater input
Trigger output
RS232 connection
Use this connector To connect to this
DIN COMMS Other Meridian G Series, 500 Series, or 800 Series equipment, or Meridian DSP loudspeakers.
RS232 connection A computer, for configuring the digital surround controller.
USB connection A computer, for configuring the digital surround controller.
IR IN A G12 IR Receiver, or approved alternative infra-red receiver. Contact your dealer for details.
TRIG 1 Other equipment, via a mono 3.5mm jack plug output (centre pin hot) providing 12VDC. It is
always low in standby. By default it is high for all sources, so can be used to bring a G Series
power amplifier out of standby. Alternatively you can program it to be high for specific sources;
eg to control a projection screen.
Communications connections