User guide

23
Customising the
G65 Digital Surround
Controller
SpeakerLink controls
Certain Meridian DSP loudspeakers provide additional
digital processing features that can be controlled by the
G65 Digital Surround Controller.
To access these features you need to:
Connect to the DSP loudspeakers via the
SpeakerLink connection.
Enable the SpeakerLink controls using the Meridian
Configuration Application (see Installing the Meridian
Configuration Application, page 53), or via the
SpeakerLink menu (see Settings , page 52).
The settings for each control are stored in the DSP
preset (see Defining your own presets , page 26),
allowing you to customise the settings for each source.
The Centre Elevation control raises the image
projected by the centre speaker. This creates a
much more involving movie experience, with superior
image integration across the whole width of the audio
presentation.
The Enhanced Bass Alignment control improves
the presentation of music. Note that the extra
processing adds a time delay, so it should be disabled
for video sources unless the video delay can be
adjusted to compensate.
You may need to update the firmware in your
SpeakerLink-enabled DSP loudspeakers to access
these features.
•
•
To change the Centre Elevation
Press < or > until the display shows the current
Centre Elevation setting.
For example:
#$#%LEV/FF
st uv wxy !SSIGNz{|
Press up or down to select between Off, Min, Med,
or Max.
To change the Enhanced Bass
Alignment
Press < or > until the display shows the current
Enhanced Bass Alignment setting.
For example:
#$%"!/N
st uv wxy !SSIGNz{|
Press A or V to choose between On or Off.
•
•