Specifications

Tr o u b l e s h o o t i n g
2 6
Processor operation
The LCD is displaying an OVERHEAT WARNING.
The DVP-1080 processor possesses thermal protection circuitry which actively monitors
internal temperature during operation. Excessive heat may cause the processor to
malfunction, and/or, shorten product lifespan.
• Do not mount processor above power amplifiers or other equipment which generate
excessive heat
• Allow a minimum of one rack space, above and below the unit, for proper ventilation
(1RU or 1.75”).
• Insure there is adequate system rack ventilation (preempts failure with additional
installed equipment)
• LEVEL 1 WARNING / HIGH TEMPERATURE
Internal Temperature is exceeding safe operational limits. Steps should be taken to improve
ventilation
• LEVEL 2 WARNING / HIGH TEMPERATURE
Internal Temperature is at critical thermal limits; processor failure may occur. Immediate
steps should be
implemented, to improve ventilation, and return the unit to optimal operational
temperature
• LEVEL 3 WARNING / EXTREME TEMPERATURE
Internal Temperature has exceeded maximum thermal limitations; processor will shut down.
• A LEVEL 3 WARNING will only display for Five (5) Seconds, then the DVP-1080 will shut
down
• DVP-1080 cannot be powered ON by the front panel power button during this condition
• A LEVEL 3 WARNING indication requires the unit first be unplugged to reset
• Normal operation resumes once the DVP-1080 has returned to optimal thermal
temperature
How do I Store a Profile?
A stored PROFILE is merely a “Snap-Shot-In-Time” for all settings which have been selected
from both the SETUP MENU options (LCD), or the USER MENU (OSD) options, within the
DVP1080 processor, and programmed into the processor’s CPU.
System SETUP MENU Option (LCD)
• Enter the SETUP MENU by pressing
Menu on the IR remote for seven seconds
• Select all applicable changes required for the intended PROFILE within the SETUP MENU
• Press
Menu to exit the SETUP MENU
• Then, proceed to…
On-screen USER MENU Options (OSD)
• Press
Menu to view the On-Screen Display (OSD)
• Adjust all applicable changes required for the intended PROFILE
• Under the menu tab INPUT, use
V to highlight PROFILE
• Press the
> to select numeric PROFILE
• Press
Store.
• Press
Menu to exit the On-Screen Display.
When I select 4:3 on the IR remote, the image is not centered
This essentially means the innate 16:9 image from the DVP-1080, when selecting
ANAMORPHIC, is not properly centered on the display device.
• Utilize a DVD ‘Screen Area’ test pattern (DVD Essentials, AVIA, etc.)
• Center, and position the image for a 2.5% over-scan, using the displays sizing and
positioning controls.
• Once the image has been properly centered, sized and positioned (utilizing the display
controls), the 4:3 image will fall-in-to-place and be centered within the 16:9 display
area.
Note: Do not view a 4:3 images for prolonged periods of time on a 16:9 display; image
Burn-In may occur. Image Burn-In is not covered under the warranty.