Specifications

I n s t a l l i n g t h e
d i g i t a l v i d e o
p r o c e s s o r
1 0
Use this connector To connect to this
IR LEAD An external infra-red receiver via a 3.5mm stereo jack plug: Tip =
+, Sleeve = Ground, Ring not connected.
SCREEN A 12V trigger connection for use with an electronic screen or
other device requiring a 12V trigger signal. The connection can
be programmed for on/off operation in the
SETUP menu or
via RS232. Use a 3.5mm 2-pin connector Tip = +12V, Sleeve =
Ground, 100milliamps maximum.
RS232 OPTION Provides switching signals to control some Meridian/Faroudja
projector functions including power on/off and 50/60Hz frame
rate.
RS232 CONTROL Allows the DVP1080HD to be controlled from an external device
such as an AMX or Creston control system.
Connecting power
Before connecting power, check the rating markings on the underside of the unit to ensure
that the product is the correct voltage for your mains supply.
• Connect the AC INPUT on the back panel to a suitable mains supply, using the power
cord supplied with the DVP1080HD.
To disconnect the DVP1080HD from the mains supply at any time remove the appliance
connector or the mains plug.
For this reason the appliance connector or the mains plug must remain accessible when the
apparatus is in use. The socket-outlet should be near the equipment and easily accessible.
Communications connections
ANALOG INPUTS
PASS-THRU MONITOR RED/Pr GREEN/r BLUE/Pb
RS-232 CONTROL
AC INPUT
RS-232 OPTIONDVI OUTPUTSCREENIR LIDDVI INPUT
H SYNC V SYNCC/SYNCVIDEOS-VIDEO
ANALOG OUTPUTS
RS232
Option
RS232
Control
IR receiver
Trigger