Specifications

I n s t a l l i n g t h e
d i g i t a l v i d e o
p r o c e s s o r
8
Use this output To connect to this
D15 A computer monitor, or for use as a second video output.
Component video
RGBHV/YPbPr
A high scan rate analogue display with RGBHV or YPrPb
analogue inputs.
DVI output A compatible digital display that uses single link DVI COMM
activity.
To connect a DVI projector or display (eg Meridian/Faroudja
D-ILA1080MF1)
DVP1080HD Digital Video processor
• Connect the DVI output to the DVI input of the projector or display using a high-quality
DVI cable.
If you are using a Meridian projector:
• Connect the RS232 OPTION output from the DVP1080HD to the RS232 input of the
projector using the RS232 cable supplied with the projector.
Using cables not rated for the resolution being used will result in images with colour
sparkles and lines, or no image at all. Always verify the maximum resolution of the cable
with the cable supplier. A Meridian HDMAX 121 cable extender may be used at the far end
of an HDMI cable to resolve difficulties in many cases.
For 1080p, fibre optic cables should be used for lengths over 4.5m (15') (or any cable rated
for 1600x1200 resolution. Check with cable supplier).
The processor monitors the DVI input and output status and provides the following
information on the front panel display:
Display Explanation
DVI Input signal is supported
NO INPUT No signal is detected.
DVI PASS-THROUGH A VESA rate has been detected and sent to the output
unprocessed.
RATE NOT SUPPORTED A VESA or non-video rate has been detected but the selected
output is analogue RGB or YPrPb.
Video outputs
ANALOG INPUTS
PASS-THRU MONITOR RED/Pr GREEN/r BLUE/Pb
RS-232 CONTROL
AC INPUT
RS-232 OPTIONDVI OUTPUTSCREENIR LIDDVI INPUT
H SYNC V SYNCC/SYNCVIDEOS-VIDEO
ANALOG OUTPUTS
DVI/HDMI
Component/RGBHV
video
D15F